Workshop & Manufacturing
Uniform Stock Cutting with Kerf Calculator
Count identical pieces cut from one stock length while accounting for end trim and one saw kerf per piece.
How the calculation works
Complete finished pieces = floor((stock-trim)/(piece+kerf)) pieces. Finished material yield = floor((stock-trim)/(piece+kerf))*piece/stock*100 %. Residual stock after allocated cuts = stock-trim-floor((stock-trim)/(piece+kerf))*(piece+kerf) mm. Total kerf loss = floor((stock-trim)/(piece+kerf))*kerf mm.
Worked example
Example inputs — Original stock length (mm): 3000; Finished piece length (mm): 450; Saw kerf per completed piece (mm): 3; Total end trim removed before cutting (mm): 10. Expected results — Complete finished pieces: 6 pieces; Finished material yield: 90 %; Residual stock after allocated cuts: 272 mm; Total kerf loss: 18 mm.
Assumptions and limits
One full kerf is reserved for each completed piece, including the last; this convention is deliberately conservative when an exact end piece needs no cut. Identical lengths only, no mixed-length cutting optimisation.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Milling Speed, Feed, Removal & Time Calculator
- Turning Pass Time, Removal & Finish Calculator
- Ball Nose Effective Diameter & Scallop Calculator
- Radial Chip Thinning Feed Correction Calculator
- Drill Point, Feed Travel & Time Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.