Workshop & Manufacturing
Turning Pass Time, Removal & Finish Calculator
Estimate a constant-diameter turning pass and the ideal cusp height from a circular tool nose.
How the calculation works
Surface cutting speed = pi*diameter*rpm/1000 m/min. Axial feed rate = feed*rpm mm/min. Feed-only time = length/(feed*rpm) min. Conventional removal rate = pi*diameter*rpm/1000*depth*feed cm³/min. Geometric peak-to-valley cusp = (nose-sqrt(nose**2-(feed/2)**2))*1000 µm.
Worked example
Example inputs — Machined diameter (mm): 50; Spindle speed (rpm): 1000; Feed per revolution (mm/rev): 0.2; Radial depth of cut (mm): 1; Feed length including allowances (mm): 100; Tool nose radius (mm): 0.8. Expected results — Surface cutting speed: 157.0796327 m/min; Axial feed rate: 200 mm/min; Feed-only time: 0.5 min; Conventional removal rate: 31.41592654 cm³/min; Geometric peak-to-valley cusp: 6.274606681 µm.
Assumptions and limits
Planning arithmetic, not a machine setup recommendation. Toolmaker limits, workholding, runout, material, cooling and machine capability must be checked separately. Constant diameter/RPM. Ideal cusp is not measured Ra and excludes vibration, edge shape and material effects. Removal uses the conventional cutting-diameter approximation.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Milling Speed, Feed, Removal & Time Calculator
- Ball Nose Effective Diameter & Scallop Calculator
- Radial Chip Thinning Feed Correction Calculator
- Drill Point, Feed Travel & Time Calculator
- Circular Interpolation Tool-Centre Feed Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.