Workshop & Manufacturing
Radial Chip Thinning Feed Correction Calculator
Estimate the programmed feed per tooth needed to achieve a target maximum chip thickness at shallow radial engagement.
How the calculation works
Chip-thickness factor = sqrt(1-(1-2*engagement/diameter)**2) if engagement < diameter/2 else 1 ratio. Corrected feed per tooth = target/(sqrt(1-(1-2*engagement/diameter)**2) if engagement < diameter/2 else 1) mm/tooth. Corrected table feed = target/(sqrt(1-(1-2*engagement/diameter)**2) if engagement < diameter/2 else 1)*rpm*teeth mm/min.
Worked example
Example inputs — Cutter diameter (mm): 10; Radial engagement (mm): 1; Target maximum chip thickness (mm): 0.04; Spindle speed (rpm): 5000; Effective teeth: 4. Expected results — Chip-thickness factor: 0.6 ratio; Corrected feed per tooth: 0.06666666667 mm/tooth; Corrected table feed: 1333.333333 mm/min.
Assumptions and limits
Planning arithmetic, not a machine setup recommendation. Toolmaker limits, workholding, runout, material, cooling and machine capability must be checked separately. Straight peripheral cutting edge at 90° entering angle. At engagement of half diameter or greater the maximum chip-thickness factor is one. Does not model ball, round-insert or lead-angle thinning.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Milling Speed, Feed, Removal & Time Calculator
- Turning Pass Time, Removal & Finish Calculator
- Ball Nose Effective Diameter & Scallop Calculator
- Drill Point, Feed Travel & Time Calculator
- Circular Interpolation Tool-Centre Feed Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.