Workshop & Manufacturing
Circular Interpolation Tool-Centre Feed Calculator
Convert desired wall feed into cutter-centre feed for internal or external circular contouring.
How the calculation works
Tool-centre path diameter = feature-tool if side == "internal" else feature+tool mm. Programmed tool-centre feed = wall_feed*(feature-tool if side == "internal" else feature+tool)/feature mm/min. One full contour time = pi*feature/wall_feed min.
Worked example
Example inputs — Finished feature diameter (mm): 40; Cutter diameter (mm): 10; Desired feed at feature surface (mm/min): 400; Contour side: internal. Expected results — Tool-centre path diameter: 30 mm; Programmed tool-centre feed: 300 mm/min; One full contour time: 0.3141592654 min.
Assumptions and limits
Planning arithmetic, not a machine setup recommendation. Toolmaker limits, workholding, runout, material, cooling and machine capability must be checked separately. Planar circular path with no helical pitch. Check whether the controller already applies contour-feed compensation before using this conversion.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Milling Speed, Feed, Removal & Time Calculator
- Turning Pass Time, Removal & Finish Calculator
- Ball Nose Effective Diameter & Scallop Calculator
- Radial Chip Thinning Feed Correction Calculator
- Drill Point, Feed Travel & Time Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.