Workshop & Manufacturing
Rectangular Sheet Grid Cutting Yield Calculator
Compare two uniform orientations for rectangular parts on a sheet with a cutting gap and edge margins.
How the calculation works
Unrotated grid parts = floor((sheet_x-2*margin+gap)/(part_x+gap))*floor((sheet_y-2*margin+gap)/(part_y+gap)) parts. Rotated grid parts = floor((sheet_x-2*margin+gap)/(part_y+gap))*floor((sheet_y-2*margin+gap)/(part_x+gap)) parts. Best uniform grid count = max(floor((sheet_x-2*margin+gap)/(part_x+gap))*floor((sheet_y-2*margin+gap)/(part_y+gap)),floor((sheet_x-2*margin+gap)/(part_y+gap))*floor((sheet_y-2*margin+gap)/(part_x+gap))) parts. Best uniform material utilisation = max(floor((sheet_x-2*margin+gap)/(part_x+gap))*floor((sheet_y-2*margin+gap)/(part_y+gap)),floor((sheet_x-2*margin+gap)/(part_y+gap))*floor((sheet_y-2*margin+gap)/(part_x+gap)))*part_x*part_y/(sheet_x*sheet_y)*100 %.
Worked example
Example inputs — Sheet length (mm): 1000; Sheet width (mm): 600; Part length (mm): 180; Part width (mm): 100; Inter-part cut gap (mm): 2; Margin on each sheet edge (mm): 10. Expected results — Unrotated grid parts: 25 parts; Rotated grid parts: 27 parts; Best uniform grid count: 27 parts; Best uniform material utilisation: 81 %.
Assumptions and limits
Compares aligned grids with every part in the same orientation. Mixed-orientation nesting may fit more; grain, heat spacing, lead-ins, clamps and defects are excluded. Gap includes the complete required separation, not a per-side allowance.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Milling Speed, Feed, Removal & Time Calculator
- Turning Pass Time, Removal & Finish Calculator
- Ball Nose Effective Diameter & Scallop Calculator
- Radial Chip Thinning Feed Correction Calculator
- Drill Point, Feed Travel & Time Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.