Networking
RTP Interarrival Jitter EWMA Calculator
Apply the RTP smoothing recurrence to a sequence of packet transit-time observations.
How the calculation works
Final smoothed interarrival jitter = rtp_jitter(transit,initial) ms. Packets in supplied sequence = count(transit) packets.
Worked example
Example inputs — Relative transit times in milliseconds, in receive order: 10, 14, 12; Initial jitter estimate in milliseconds: 0. Expected results — Final smoothed interarrival jitter: 0.359375 ms; Packets in supplied sequence: 3 packets.
Assumptions and limits
Offline planning arithmetic: this calculator sends no packets and changes no device configuration. Actual routing, reservations, implementation limits and measured network conditions must be checked separately. Uses J ← J + (|transit_i−transit_(i−1)|−J)/16. Transit observations must already use one clock unit and the appropriate sender/receiver timestamp alignment; this is not peak-to-peak delay variation.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- IPv4 Subnet, Host Range & Mask Calculator
- Smallest IPv4 Covering Prefix Calculator
- IPv4 Range to Exact CIDR Blocks Calculator
- IPv4 VLSM Host Requirement Planner
- IPv6 Prefix & Exact Address Capacity Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.