Electronics
DC Cable Resistance & Voltage Drop Calculator
Calculate a two-conductor DC loop’s resistance, voltage drop and loss using conductor resistivity.
How the calculation works
Out-and-return loop resistance = 2*one_way_length*resistivity/area ohms. Loop voltage drop = 2*one_way_length*resistivity/area*current V. Resistive cable loss = 2*one_way_length*resistivity/area*current**2 W. Load voltage in this model = supply-2*one_way_length*resistivity/area*current V.
Worked example
Example inputs — One-way cable distance (m): 10; Each conductor cross-section (mm²): 2.5; Conductor resistivity at operating temperature (ohm·mm²/m): 0.0175; DC load current (A): 10; Source voltage (V): 12. Expected results — Out-and-return loop resistance: 0.14 ohms; Loop voltage drop: 1.4 V; Resistive cable loss: 14 W; Load voltage in this model: 10.6 V.
Assumptions and limits
Idealized circuit arithmetic. Component ratings, tolerances, temperature, transients, isolation and electrical safety require independent checks; this tool does not certify a circuit. Equal outward and return conductors, fixed current, no connector resistance. This does not select safe ampacity, insulation, protection or code-compliant wire size.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Resistive Load Current & Dissipation Calculator
- Three Resistor Series & Parallel Calculator
- Three Capacitor Series & Parallel Calculator
- Uncoupled Inductor Network Calculator
- Loaded Voltage Divider Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.