Electronics
Reservoir Capacitor Rectifier Ripple Calculator
Estimate peak-to-peak capacitor ripple for a half-wave or full-wave rectifier supplying a nearly constant load.
How the calculation works
Ripple frequency = line_frequency*(2 if rectification == "full" else 1) Hz. Approximate peak-to-peak ripple = load_current/(line_frequency*(2 if rectification == "full" else 1)*capacitance*1e-6) V.
Worked example
Example inputs — AC input frequency (Hz): 50; Reservoir capacitance (µF): 1000; DC load current (A): 0.1; Rectification: full. Expected results — Ripple frequency: 100 Hz; Approximate peak-to-peak ripple: 1 V.
Assumptions and limits
Idealized circuit arithmetic. Component ratings, tolerances, temperature, transients, isolation and electrical safety require independent checks; this tool does not certify a circuit. Small-ripple approximation with short recharge intervals. Excludes diode drops, transformer impedance, capacitor ESR, surge current and ripple-current rating.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Resistive Load Current & Dissipation Calculator
- Three Resistor Series & Parallel Calculator
- Three Capacitor Series & Parallel Calculator
- Uncoupled Inductor Network Calculator
- Loaded Voltage Divider Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.