Electronics
555 Astable & Monostable Timing Calculator
Calculate nominal astable timing and monostable pulse width from the classic 555 resistor-capacitor network.
How the calculation works
Astable high time = log(2)*(r_a+r_b)*capacitance*1e-6 s. Astable low time = log(2)*r_b*capacitance*1e-6 s. Astable frequency = 1/(log(2)*(r_a+2*r_b)*capacitance*1e-6) Hz. Approximate monostable pulse = 1.1*r_a*capacitance*1e-6 s.
Worked example
Example inputs — Astable RA or monostable R (ohms): 10000; Astable RB (ohms): 10000; Timing capacitance (µF): 1. Expected results — Astable high time: 0.01386294361 s; Astable low time: 0.006931471806 s; Astable frequency: 48.0898347 Hz; Approximate monostable pulse: 0.011 s.
Assumptions and limits
Idealized circuit arithmetic. Component ratings, tolerances, temperature, transients, isolation and electrical safety require independent checks; this tool does not certify a circuit. Conventional astable network without steering diodes. Datasheet resistor ranges, leakage, discharge limits and timing tolerances must be checked.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Resistive Load Current & Dissipation Calculator
- Three Resistor Series & Parallel Calculator
- Three Capacitor Series & Parallel Calculator
- Uncoupled Inductor Network Calculator
- Loaded Voltage Divider Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.