Electronics
MOSFET Gate Drive Current & Power Calculator
Estimate gate charging power, average gate current and nominal edge-current demand.
How the calculation works
Average charge current = gate_charge*1e-9*frequency*1000 A. Gate charging power = gate_charge*1e-9*gate_voltage*frequency*1000 W. Average current during charge edge = gate_charge/edge_time A.
Worked example
Example inputs — Total gate charge at operating conditions (nC): 30; Gate-drive voltage swing (V): 10; Switching frequency (kHz): 100; Desired gate charge time (ns): 50. Expected results — Average charge current: 0.003 A; Gate charging power: 0.03 W; Average current during charge edge: 0.6 A.
Assumptions and limits
Idealized circuit arithmetic. Component ratings, tolerances, temperature, transients, isolation and electrical safety require independent checks; this tool does not certify a circuit. Total gate charge must match the actual drain voltage and current. Q/t is an average edge demand, not a complete gate-loop or Miller-plateau simulation.
Reference and further reading
Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.
Related calculators
- Resistive Load Current & Dissipation Calculator
- Three Resistor Series & Parallel Calculator
- Three Capacitor Series & Parallel Calculator
- Uncoupled Inductor Network Calculator
- Loaded Voltage Divider Calculator
Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.