Crafts, Fabric & Paper

Wound Paper, Film & Tape Roll Length Calculator

Estimate length and material mass from a flat strip roll’s diameters, layer thickness and effective packing fraction.

How the calculation works

Annular area = π(outer diameter²−core diameter²)/4. Effective solid cross-section = annular area × packing fraction. Strip length = effective cross-section / layer thickness. Multiply effective cross-section by axial width for volume and by density for material mass, with explicit mm-to-m/cm³ conversions.

Worked example

Example inputs — Outside roll diameter (mm): 100; Outside diameter of the winding core (mm): 50; Material single-layer thickness (mm): 0.1; Material/roll axial width (mm): 100; Effective solid material fraction of annulus: 0.9; Material density (g/cm³): 1.2. Expected results — Effective material cross-section area: 5301.437603 mm²; Flat material length: 53.01437603 m; Effective material volume: 530.1437603 cm³; Estimated material mass excluding core: 636.1725124 g.

Assumptions and limits

Planning estimate using your measurements. Make a representative sample and check the stated cutting, seam, gauge and rounding conventions before buying or cutting material. Flat strip of constant thickness and full axial width, wound uniformly around a cylindrical core. Packing accounts approximately for voids/compression and must be chosen from real measurements. Excludes core weight, taper, telescoping and nonuniform thickness; this is not a round-wire spool capacity model.

Reference and further reading

Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.

Related calculators

Browse all 1000 calculators →

Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.