Crafts, Fabric & Paper

Knife & Box Pleated Panel Fabric Calculator

Calculate flat panel width from finished width, repeat count and explicitly defined fold-back depth.

How the calculation works

Finished visible face width per repeat = finished/pleats cm. Fabric taken up inside all folds = pleats*depth*(2 if kind == "knife" else 4) cm. Flat panel width including outer allowances = finished+pleats*depth*(2 if kind == "knife" else 4)+2*side cm. Flat repeat pitch before outer allowances = finished/pleats+depth*(2 if kind == "knife" else 4) cm. Fullness ratio excluding outer allowances = (finished+pleats*depth*(2 if kind == "knife" else 4))/finished ratio.

Worked example

Example inputs — Finished span across all pleats (cm): 80; Number of equal pleat repeats: 8; Depth of each fold-back leg (cm): 5; Flat seam/hem allowance on each outer side (cm): 1; Pleat structure: knife. Expected results — Finished visible face width per repeat: 10 cm; Fabric taken up inside all folds: 80 cm; Flat panel width including outer allowances: 162 cm; Flat repeat pitch before outer allowances: 20 cm; Fullness ratio excluding outer allowances: 2 ratio.

Assumptions and limits

Planning estimate using your measurements. Make a representative sample and check the stated cutting, seam, gauge and rounding conventions before buying or cutting material. Fold-back depth is one leg: a knife repeat uses 2×depth of hidden fabric, a box/inverted box uses 4×depth. Depth may differ from visible face width, so 3:1 fullness is not imposed. This is panel-width geometry; panel height, internal joining seams, fabric width and pleat pressing behaviour are not inferred.

Reference and further reading

Read the underlying subject reference. Calculith is an independent implementation; the reference does not endorse or certify this tool.

Related calculators

Browse all 1000 calculators →

Example values are editable. Results are estimates where assumptions apply. Calculations run in your browser. Updated 2026-11-16.